Cisco ASR 14000 Series Management Command Reference page 705

Terminal Services Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
session-timeout
To set the timeout interval for all outgoing connections from the current terminal, use the
session-timeout command in the appropriate line configuration mode. To remove the session-timeout
command from the configuration file and restore the system to its default condition, use the no form of
this command.
Syntax Description minutes
output
Defaults
minutes: 10 minutes
Command Modes Line console configuration
Line default configuration
Line template configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the session-timeout command to set the interval that the Cisco IOS XR software waits for traffic
before closing the connection to a remote device and returning the terminal to an idle state. If the output
keyword is not specified, the session timeout interval is based solely on detected input from the user. If
the output keyword is specified, the interval is based on input and output traffic.
Task ID Task ID
tty-access
Examples
The following example shows how to set the session timeout value for the default line template to
120 minutes (2 hours):
RP/0/RP0/CPU0:router(config)# line default
RP/0/RP0/CPU0:router(config-line)# session-timeout 120
OL-17231-01
session-timeout minutes [output]
no session-timeout minutes
Timeout interval in minutes. Range is 0 to 35791 minutes. The default is 10
minutes.
(Optional) Specifies that when traffic is sent to an asynchronous line from
the router (within the specified interval), the connection is retained.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Cisco ASR 14000 Series Router System Management Command Reference
session-timeout
SMR-703