Cisco ASR 14000 Series Management Command Reference page 268

hw-module reset auto
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
hw-module reset auto
To reset a specific node, use the hw-module reset auto command in administration configuration mode.
To disable the reset feature on a specific node, use the no form of this command.
Syntax Description
disable
location node-id
Defaults The node reset feature is enabled for all nodes.
Command Modes
Administration configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The hw-module reset auto command is used to reload Cisco IOS XR software on a specific node. The
node reloads with the current running configuration and active software set for that node.
Task ID Task ID
root-system
root-lr
Examples The following example shows how to reload a node:
RP/0/RP0/CPU0:router # admin
RP/0/RP0/CPU0:router(admin)# configure
RP/0/RP0/CPU0:router(admin-config)# hw-module reset auto location 0/2/CPU0
RP/0/RP0/CPU0:router# RP/0/RP0/CPU0:Apr
HELFMGR-3-USER_RESET : Node 0/2/CPU0 is reset due to user reload request
Cisco ASR 14000 Series Router System Management Command Reference
SMR-266
hw-module reset auto [disable] location node-id
no hw-module reset auto [disable] location node-id
(Optional) Disables the node reset feature on the specified node.
Identifies the node you want to reload. The node-id argument is entered in
the rack/slot/module notation.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
read, write
Hardware Redundancy and Node Administration Commands on Cisco IOS XR Software
2 22:04:43.659 : shelfmgr[294]: %S
OL-17231-01