Cisco ASR 14000 Series Management Command Reference page 657

SNMP Server Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
When an SNMP trap is sent from a Cisco SNMP device, it has a notification address of the interface it
happened to exit at that time. Use the snmp-server trap-source command to monitor notifications from
a particular interface.
Task ID Task ID
snmp
Examples
The following example shows how to specify that the IP address for Packet-over-SONET/SDH (POS)
interface 0/0/1/0 is the source for all SNMP notifications:
RP/0/RP0/CPU0:Router(config)# snmp-server trap-source POS 0/0/1/0
Related Commands Command
snmp-server engineid
snmp-server host
snmp-server traps bgp
snmp-server traps snmp
snmp-server traps syslog
OL-17231-01
Operations
read, write
Description
Specifies the identification number of the local SNMP engine.
Specifies the recipient of an SNMP notification operation.
Enables BGP state-change SNMP notifications.
Enables RFC 1157 SNMP notifications.
Enables SNMP notifications for Cisco-syslog-MIB error messages.
Cisco ASR 14000 Series Router System Management Command Reference
snmp-server trap-source
SMR-655