Cisco ASR 14000 Series Management Command Reference page 270

hw-module shutdown
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
hw-module shutdown
To administratively shut down a specific node, use the hw-module shutdown command in
administration configuration mode. To return a node to the up state, use the no form of this command.
Syntax Description
location node-id
Defaults Nodes are in the up state.
Command Modes Administration configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Nodes that are shut down still have power, but cannot load or operate Cisco IOS XR software.
Route processors (RPs) cannot be administratively shut down.
Note
Enter the show platform command in EXEC mode to display the results of the hw-module shutdown
command.
Task ID Task ID
root-system
root-lr
Examples The following example shows how to administratively shut down the node 0/2/CPU0:
RP/0/RP0/CPU0:router # admin
RP/0/RP0/CPU0:router(admin)# configure
RP/0/RP0/CPU0:router(admin-config)# hw-module shutdown location 0/2/CPU0
Cisco ASR 14000 Series Router System Management Command Reference
SMR-268
hw-module shutdown location node-id
no hw-module shutdown location node-id
Identifies the node you want to shut down. The node-id argument is
expressed in the rack/slot/module notation.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
read, write
Hardware Redundancy and Node Administration Commands on Cisco IOS XR Software
OL-17231-01