Cisco ASR 14000 Series Management Command Reference page 635

SNMP Server Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
snmp-server traps mpls l3vpn
To enable the sending of MPLS Layer 3 VPN Simple Network Management Protocol (SNMP)
notifications, use the snmp-server traps mpls l3vpn command in global configuration mode. To disable
MPLS Layer 3 VPN SNMP notifications, use the no form of this command.
Syntax Description all
max-threshold-cleared
max-threshold-exceeded
max-threshold-reissue-notif-time
seconds
mid-threshold-exceeded
vrf-down
vrf-up
Defaults SNMP notifications are disabled by default.
Command Modes Global configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Task ID Task ID
snmp
Examples The following example shows how to enable the device to send MPLS Layer 3 VPN traps:
RP/0/RP0/CPU0:Router(config)# snmp-server traps mpls l3vpn all
OL-17231-01
snmp-server traps mpls l3vpn {all | max-threshold-cleared | max-threshold-exceeded |
max-threshold-reissue-notif-time | mid-threshold-exceeded | vrf-down | vrf-up}
no snmp-server traps mpls l3vpn
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Enables all MPLS Layer 3 VPN traps.
Enables maximum threshold cleared traps.
Enables maximum threshold exceeded traps.
Specifies the time interval, in seconds, for reissuing a
maximum threshold notification.
Enables mid-threshold exceeded traps.
Enables VRF down traps.
Enables VRF up traps.
Cisco ASR 14000 Series Router System Management Command Reference
snmp-server traps mpls l3vpn
SMR-633