Cisco ASR 14000 Series Management Command Reference page 437

NTP Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
interface (NTP)
To configure a Network Time Protocol (NTP) interface, use the interface command in NTP
configuration mode. To disable an NTP interface, use the no form of this command.
Syntax Description.
type
interface-id
disable
Defaults No NTP interfaces are configured.
Command Modes NTP interface configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the interface (NTP) command to place the router in NTP interface configuration mode, from which
NTP broadcast servers and broadcast clients can be configured. By default, after the NTP process is
started, NTP features become available for all interfaces. To exit NTP interface configuration mode, use
the exit command.
Task ID Task ID
ip-services
Examples The following example shows how to enter NTP configuration mode, specify an NTP interface to be
configured, and enter NTP interface configuration mode:
RP/0/RP0/CPU0:router(config)# ntp
RP/0/RP0/CPU0:router(config-ntp)# interface POS 0/1/0/0
RP/0/RP0/CPU0:router(config-ntp-int)
OL-17231-01
interface type interface-id [disable]
Interface type. For more information, use the question mark (?) online help
function.
Identifies a physical interface or a virtual interface.
Note
For more information about the syntax for the router, use the question mark
(?) online help function.
(Optional) Disables the NTP interface.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Use the show interfaces command to see a list of all possible
interfaces currently configured on the router.
Cisco ASR 14000 Series Router System Management Command Reference
interface (NTP)
SMR-435