Cisco ASR 14000 Series Management Command Reference page 665

SNMP Server Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
snmp-server vrf
To configure the VPN routing and forwarding (VRF) properties of Simple Network Management
Protocol (SNMP), use the snmp-server vrf command in global configuration mode. To remove the
configuration, use the no form of this command.
Syntax Description vrf-name
host address
clear
encrypted
traps
version {1 | 2c | 3}
security-level
string
udp-port port
context context-name
Defaults No default behavior or values
Command Modes Global configuration
Command History Release
Release 3.7.1
OL-17231-01
snmp-server vrf vrf-name [host address [clear | encrypted] [traps] [version {1 | 2c | 3
security-level}] community-string [udp-port port]] [context context-name]
no snmp-server vrf vrf-name
Name of the VRF.
(Optional) Specifies the name or IP address of the host (the targeted
recipient).
(Optional) Specifies that the community-string argument is clear text.
(Optional) Specifies that the community-string argument is encrypted text.
(Optional) Specifies that notifications should be sent as traps. This is the
default.
(Optional) Specifies the version of the SNMP used to send the traps. The
default is SNMPv1. When the version keyword is used, one of the following
keywords must be specified:
•
•
•
(Optional) Security level for SNMPv3. Options are:
•
•
•
Specifies the community string for SNMPv1 and SNMPv2, or the SNMPv3
user.
(Optional) Specifies the UDP port to which notifications should be sent.
(Optional) Name of the context that must be mapped to VRF identified by
value of the vrf-name argument.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
1—SNMPv1
2c—SNMPv2C
3—SNMPv3
auth—authNoPriv
noauth—noAuthNoPriv
priv—authPriv
Cisco ASR 14000 Series Router System Management Command Reference
snmp-server vrf
SMR-663