Cisco ASR 14000 Series Management Command Reference page 23

Boot Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
reload
To reload the designated secure domain router system controller (DSDRSC), use the reload command
in EXEC mode.
Syntax Description
This command has no arguments or keywords.
Defaults No default behavior or values
Command Modes EXEC
Command History Releases
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the reload command to cause the DSDRSC to reload the Cisco IOS XR software according to the
configuration register setting (for example, 0x0 to enter ROMMON mode and 0x2 to reload the RP to
EXEC mode). If a standby DSDRSC is in the ready redundancy state, the reload command also causes
the router to fail over to the standby DSDRSC. Use the show redundancy command in EXEC mode to
display the status of the standby RP.
When the reload command is used and a failover occurs, the running (active) software configuration is
automatically maintained during failover.
Caution If a standby RP is not installed or is not in the ready state, then the router experiences a loss of service
while the active RP is reloading the Cisco IOS XR software. To view the status of the standby RP, issue
the show redundancy command in EXEC mode.
If you use the reload command and there is no available standby node, you are prompted to continue
with the reload:
RP/0/RP0/CPU0:router# reload
Standby card not present or not Ready for failover. Proceed?[confirm]
Task ID Task ID
root-lr
OL-17231-01
reload
Modifications
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
execute
Cisco ASR 14000 Series Router System Management Command Reference
reload
SMR-19