Cisco ASR 14000 Series Management Command Reference page 257

Hardware Redundancy and Node Administration Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
dsc serial
To define serial ID for a rack, use the dsc serial command in administration configuration mode. To
remove a serial ID entry from the designated shelf controller (DSC) table, use the no form of this
command.
Syntax Description
serial_Id
rack rack_num
Defaults
No default behavior or values
Command Modes Administration configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
For more information about identifying and selecting a DSC on the Cisco ASR 14000 Series Router,
refer to Cisco ASR 14000 Series Router Getting Started Guide.
Note The serial ID is the hardware serial number that identifies the chassis.
Use the show running-config command to display and verify the defined serial ID for a rack.
Task ID Task ID
system
OL-17231-01
dsc serial serial_Id rack rack_num
no dsc serial serial_Id rack rack_num
Defines a serial ID for a rack. The serial ID is included as an entry in the
DSC table. Range is from 0 through 16 characters.
Identifies the rack whose ID you are configuring to be the serial ID.
Note
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
For systems that include two line card chassis and one fabric
chassis, the line card chassis IDs are 0 and 1, and the fabric
chassis ID is F0.
Cisco ASR 14000 Series Router System Management Command Reference
dsc serial
SMR-255