Cisco ASR 14000 Series Management Command Reference page 449

NTP Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
show ntp associations
To display the status of Network Time Protocol (NTP) associations, use the show ntp associations
command in privileged EXEC mode.
Syntax Description
detail
location node-id
Defaults
No defaults behavior or values
Command Modes EXEC
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Task ID Task ID
ip-services
Examples
The following is sample output from the show ntp associations command:
RP/0/RP0/CPU0:router# show ntp associations
*~172.19.69.1
* master (synced), # master (unsynced), + selected, - candidate, ~configured
Table 52
Table 52
Field
*
#
OL-17231-01
show ntp associations [detail] [location node-id]
(Optional) Displays detailed information about each NTP association.
(Optional) Displays the status of NTP associations from the designated
node. The node-id argument is entered in the rack/slot/module notation.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read
address ref clock
171.68.10.150
describes the significant fields shown in the display.
show ntp associations Field Descriptions
st when poll reach
2 4 64
Description
Peer is synchronized to this peer.
Peer is the best synchronization source, but the peer is
currently not synchronized. This is normally a short-lived
and intermediate stage.
Cisco ASR 14000 Series Router System Management Command Reference
show ntp associations
delay offset disp
3 2.0 -3.79 0.0
SMR-447