Cisco ASR 14000 Series Management Command Reference page 351

Software Package Management Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
location node-id
asynchronous
synchronous
parallel-reload
prompt-level {default |
none}
if-active
sdr OWNER
Defaults Packages are added to the storage device, but are not activated.
The operation is performed in asynchronous mode: The install add command runs in the background,
and the EXEC prompt is returned as soon as possible.
Command Modes EXEC
Administration EXEC
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the install add command to unpack the package software files from a PIE file and copy them to the
boot device (usually disk0).
OL-17231-01
(Optional) Activates a package on the designated node. The node-id
argument is expressed in rack/slot/module notation.
Note A package cannot be activated on a single node unless some
version of the package being activated is already active on all
nodes. For example, a Multiprotocol Label Switching (MPLS)
package cannot be active on only one node. If a version of the
MPLS package is already active on all nodes, an MPLS package
then could be upgraded or downgraded on a single node.
(Optional) Performs the command in asynchronous mode. In
asynchronous mode, this command runs in the background, and the
EXEC prompt is returned as soon as possible. This is the default mode.
(Optional) Performs the command in synchronous mode. This mode
allows the installation process to finish before the prompt is returned.
(Optional) Forces all cards on the router to reload at the same time and
then come up with the new software, rather than proceeding according
to the option encoded in the install package.
(Optional) Specifies when you are prompted for input during the
procedure.
default—You are prompted only when input is required by the
•
operation.
none—You are never prompted.
•
(Optional. Administration EXEC mode only.) Activates the optional
packages only if a version is already active.
(Optional. Administration EXEC mode only.) Activates a package for a
specific secure domain router (SDR). The only SDR available is
OWNER, which refers to the entire Cisco ASR 14000 Series Router
router.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Cisco ASR 14000 Series Router System Management Command Reference
install add
SMR-349