Cisco ASR 14000 Series Management Command Reference page 488

type list boolean
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
RP/0/RP0/CPU0:router(config-track-list)# object IPSec1 not
RP/0/RP0/CPU0:router(config-track-list)# object IPSec2
RP/0/RP0/CPU0:router(config-track-list)# object PREFIX1
RP/0/RP0/CPU0:router(config-track-list)# exit
RP/0/RP0/CPU0:router(config)# track IPSec1
RP/0/RP0/CPU0:router(config-track)# type line-protocol state
RP/0/RP0/CPU0:router(config-track-line-prot)# interface GigabitEthernet 0/0/0/3
RP/0/RP0/CPU0:router(config-track-line-prot)# exit
RP/0/RP0/CPU0:router(config-track)# track IPSec2
RP/0/RP0/CPU0:router(config-track)# type line-protocol state
RP/0/RP0/CPU0:router(config-track-line-prot)# interface ATM0/2/0.1
RP/0/RP0/CPU0:router(config-track-line-prot)# exit
RP/0/RP0/CPU0:router(config)# track PREFIX1
RP/0/RP0/CPU0:router(config-track)# type route reachability
RP/0/RP0/CPU0:router(config-track-route)# route ipv4 7.0.0.0/24
RP/0/RP0/CPU0:router(config-track-route)# exit
RP/0/RP0/CPU0:router(config-track)# interface service-ipsec 1
RP/0/RP0/CPU0:router(config-if)# vrf 1
RP/0/RP0/CPU0:router(config-if)# ipv4 address 70.0.0.2 255.255.255.0
RP/0/RP0/CPU0:router(config-if)# profile vrf_1_ipsec
RP/0/RP0/CPU0:router(config-if)# line-protocol track LIST2
RP/0/RP0/CPU0:router(config-if)# tunnel source 80.0.0.2
RP/0/RP0/CPU0:router(config-if)# tunnel destination 80.0.0.1
RP/0/RP0/CPU0:router(config-if)# service-location preferred-active 0/2/0
RP/0/RP0/CPU0:router(config-if)# commit
Related Commands Command
clear type list boolean
delay
line-protocol track
object
show track
track
type line-protocol state
type route reachability
Cisco ASR 14000 Series Router System Management Command Reference
SMR-486
Description
Clears entry of type list boolean as the basis for tracking an object.
Configures the duration, in seconds, before the track or interface state
should be polled for a change in status.
Associates a specific track with an IPSec or GRE interface object.
Configures an object to be tracked.
Displays information about objects that were tracked.
Initiates or identifies a tracking process to track the status of an object; also
enters global configuration mode.
Configures tracking based on the line protocol state of an interface object.
Configures tracking based on whether or not a route is part of a particular
routing table.
Object Tracking Commands in Cisco IOS XR Software
OL-17231-01