Cisco ASR 14000 Series Management Command Reference page 320

upgrade cpuctrlbits
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
upgrade cpuctrlbits
To upgrade the CPU controller bits on all nodes that are installed in the router or on a specific node, use
the upgrade cpuctrlbits command in administration EXEC mode.
Syntax Description
all
location node-id
bootflash
disk0
disk1
internal
Defaults Default location for the ROMMON image: internal
Command Modes Administration EXEC
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The upgrade cpuctrlbits command is only applicable to boards that use the Squid CPU controller, and
not the Squirt controller. Use the show controller cpuctrl internal command to determine which CPU
controller is used in a specific card, as indicated in bold in the following example:
RP/0/RP0/CPU0:router# show controller cpuctrl internal
Cpuctrl Internal Info for node 0/1/CPU0:
Cisco ASR 14000 Series Router System Management Command Reference
SMR-318
upgrade cpuctrlbits {all | location node-id} [bootflash | disk0 | disk1 | internal]
Upgrades the CPU controller bits on all nodes installed in the router.
Upgrades the CPU controller bits on a specific node. The node-id is
expressed in the rack/slot/module notation.
Note
(Optional) Uses the images located on the bootflash to upgrade the CPU
controller on all nodes, or on the specified node.
(Optional) Uses the images located on disk0 to upgrade the CPU
controller on all nodes, or on the specified node.
(Optional) Uses the images located on disk1 to upgrade the CPU
controller on all nodes, or on the specified node.
(Optional) Uses the images located in the /pkg/bin.
Note
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Error Interrupts = 0
PCI Error Overflows = 0
PCIX Error Overflows = 0
Port Error Overflows = 0
cpuctrl Config Reg = 0x8357ffff
cpuctrl Window Size = 0x40000000 cpuctrl Port Window Size = 0x04000000
cpuctrl SHMem Size = 0x00800000
Hardware Redundancy and Node Administration Commands on Cisco IOS XR Software
Enter the show platform command to see the location of all
nodes installed in the router.
This is the default location for the ROMMON image.
Spurious Error Interrupts = 0
PCI PM Error Overflows = 0
Internal Access PCI Overflows = 0
Error Log Overflows = 0
cpuctrl Physical Offset = 0x80000000
cpuctrl SHMem Used = 0x00224fb0
OL-17231-01