Cisco ASR 14000 Series Management Command Reference page 604

snmp-server contact
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
snmp-server contact
To set the Simple Network Management Protocol (SNMP) system contact, use the snmp-server contact
command in global configuration mode. To remove the system contact information, use the no form of
this command.
Syntax Description
system-contact-string
Defaults No system contact is set.
Command Modes Global configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the snmp-server contact command to set the system contact string. Use the no form of this
command to remove the system contact information.
Task ID Task ID
snmp
Examples
The following example shows how to specify a system contact string:
RP/0/RP0/CPU0:Router(config)# snmp-server contact Dial System Operator at beeper # 27345
Related Commands Command
snmp-server location
Cisco ASR 14000 Series Router System Management Command Reference
SMR-602
snmp-server contact system-contact-string
no snmp-server contact
String that describes the system contact information. The maximum
string length is 255 alphanumeric characters.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Description
Sets the system location string.
SNMP Server Commands on Cisco IOS XR Software
OL-17231-01