Cisco ASR 14000 Series Management Command Reference page 629

SNMP Server Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
snmp-server trap link ietf
To enable the varbind used for linkUp and linkDown SNMP traps to utilize the RFC 2863 standard
varbind, use the snmp-server trap link ietf command in global configuration mode. To restore the
default value, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults The default varbind used is cisco.
Command Modes Global configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
For more information about linkUP and linkDown notifications, see RFC 2863, The Interface Group
MIB, and RFC 3418, Management Information Base (MIB) for the Simple Network Management
Protocol (SNMP).
Task ID Task ID
snmp
Examples
The following example shows how to enable the RFC 2863 standard varbind:
RP/0/RP0/CPU0:Router(config)# snmp-server trap link ietf
Related Commands Command
snmp-server engineid
snmp-server host
snmp-server traps bgp
snmp-server traps snmp
snmp-server traps syslog
OL-17231-01
snmp-server trap link ietf
no snmp-server trap link ietf
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Description
Specifies the identification number of the local SNMP engine.
Specifies the recipient of an SNMP notification operation.
Enables BGP state-change SNMP notifications.
Enables RFC 1157 SNMP notifications.
Enables SNMP notifications for Cisco-syslog-MIB error messages.
Cisco ASR 14000 Series Router System Management Command Reference
snmp-server trap link ietf
SMR-627