Cisco ASR 14000 Series Management Command Reference page 39

Boot Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
show variables boot
To display the configuration register setting and boot file setting for the route processors (RPs) in the
system, use the show variables boot command in administration EXEC mode.
Syntax Description
location node-id
all
Defaults
No default behavior or values
Command Modes Administration EXEC
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the show variables boot command to display system boot variables for the router. This command
displays the configuration register setting and boot file setting for the RPs in the system. Use the location
node-id keyword and argument to display the configuration register setting for a specific card.
The configuration register setting is set with the command config-register. The boot variable is set in
ROM Monitor mode.
Task ID Task ID
root-lr
Examples The following is sample output from the show variables boot command:
RP/0/RP0/CPU0:router# show variables boot
Node 0/RP0/CPU0:
Node 0/RP1/CPU0:
OL-17231-01
show variables boot [location {all | node-id}]
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read
BOOT variable = disk0:asr14k-os-mbi-3.3.30/mbiasr14k-rp.vm,1;
CONFREG variable = 0x2
BOOT variable = disk0:asr14k-os-mbi-3.3.30/mbiasr14k-rp.vm,1;
CONFREG variable = 0x2
Specifies the node to reload. The node-id argument is expressed in
rack/slot/module notation.
Reloads all the nodes in the system.
Cisco ASR 14000 Series Router System Management Command Reference
show variables boot
SMR-35