Cisco ASR 14000 Series Management Command Reference page 125

Configuration Management Commands on Cisco IOS XR Software
do
To execute an EXEC mode command from a configuration mode, use the do command in any
configuration mode.
Syntax Description
exec-command
Defaults No default behavior or values
Command Modes Any configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the do command in any configuration mode or configuration submode to execute EXEC mode
commands.
To display the various EXEC mode commands that are available to execute with the do command, use
the online help (?) function at the configuration mode prompt.
The configure and describe commands are not supported under the do command.
Note
Task ID Task ID
Task ID for the EXEC command that you are using
Examples The following example shows how to execute an EXEC command from interface configuration mode. In
this example, the do command displays output from the show protocols command within interface
configuration mode:
RP/0/RP0/CPU0:router(config)# interface pos 0/1/0/1
RP/0/RP0/CPU0:router(config-if)# do show protocols
Routing Protocol "BGP 1"
Address Family IPv4 Unicast:
Distance: external 20 internal 200 local 200
OL-17231-01
do exec-command
EXEC mode command to be executed.
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read
Cisco ASR 14000 Series Router System Management Command Reference
do
SMR-123