Cisco ASR 14000 Series Management Command Reference page 619

SNMP Server Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
snmp-server ipv4 dscp
To mark packets with a specific differentiated services code point (DSCP) value, use the snmp-server
ipv4 dscp command in global configuration mode. To remove matching criteria, use the no form of this
command.
Syntax Description
value
Defaults
The IP DSCP default value for SNMP traffic is 0.
Command Modes
Global configuration
Command History Release
Release 3.7.1
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
Use the snmp-server ipv4 dscp command to specify an IP DSCP value to give SNMP traffic higher or
lower priority in your network.
Task ID Task ID
snmp
Examples The following example shows how to configure the DSCP value to af32:
RP/0/RP0/CPU0:router(config)# snmp-server ipv4 dscp af32
OL-17231-01
snmp-server ipv4 dscp value
no snmp-server ipv4 dscp [value]
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Operations
read, write
Value of the DSCP. The DSCP value can be a number from 0 to 63,
or it can be one of the following keywords: default, ef, af11, af12,
af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cs1, cs2,
cs3, cs4, cs5, cs6, or cs7.
Cisco ASR 14000 Series Router System Management Command Reference
snmp-server ipv4 dscp
SMR-617