Cisco ASR 14000 Series Management Command Reference page 494

affinity location-set
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
affinity location-set
To set the affinity of a placeable program (process) to or from a group of nodes, use the affinity
location-set command in placement program configuration mode. To remove the affinity location set,
use the no form of this command.
Syntax Description [...[node-id5]]
attract
repulse
strength
default
none
Defaults There are no default location-set affinities for any placeable processes.
Specifying an affinity value of default is equivalent to specifying the attract strength argument to be
200.
Command Modes Placement program configuration
Command History Release
Release 3.7.1
Usage Guidelines To use this command, you must be in a user group associated with a task group that includes the proper
task IDs.
The affinity location-set command assigns an affinity for a process to run on a specific node, node pair
or set of up to 5 nodes.
A node pair is either an active and standby pair of nodes hosted on route processors (RPs), or a single
active node on an RP that does not have a standby.
By containing references to specific location identifiers, location-set affinities are more specific to the
individual SDR in which they are used than other affinity types.
Cisco ASR 14000 Series Router System Management Command Reference
SMR-492
affinity location-set node-id1 [...[node-id5]] {attract strength | repulse strength | default | none}
no affinity location-set node-id1 [...[node-id5]] {attract strength | repulse strength | default |
none}
Modification
This command was introduced on the Cisco ASR 14000 Series Router.
Process and Memory Management Commands on Cisco IOS XR Software
The node-id argument is expressed in the rack/slot/module notation.
To specify multiple nodes, enter the node-id for each node. You can
specify a node pair, or up to 5 nodes.
Specifies a positive affinity.
Specifies a negative affinity.
A positive or negative strength. The range is from 1 to 100000
points.
Sets the affinity location-set default value, which is equivalent to
specifying an attract strength of 200.
Sets the affinity value to zero points.
OL-17231-01