Cisco ASR 14000 Series Management Command Reference page 343

Software Package Management Commands on Cisco IOS XR Software
C i s c o C o n f i d e n t i a l - B e t a R e v i e w R 3 . 7. 1
install activate
To add software functionality to the active software set, use the install activate command in EXEC or
administration EXEC mode.
Administration EXEC Mode
EXEC Mode
Syntax Description id add-id
device:package
auto-abort-timer time
sdr OWNER
OL-17231-01
install activate {id add-id [add-id2 ... add-id16] | device:package [device:package2 ...
device:package32]} [auto-abort-timer time] [sdr OWNER] [location node-id] [if-active]
[admin-profile] [asynchronous | synchronous] [parallel-reload] [prompt-level {default |
none}] [test]
install activate {id add-id [add-id2 ... add-id16] | device:package [device:package2 ...
device:package32]} [auto-abort-timer time] [location node-id] [asynchronous |
synchronous] [parallel-reload] [prompt-level {default | none}] [test]
Specifies the ID number of an install add operation. The command
activates all packages that were added in the specified install add
operation. The ID number of an install add operation is indicated in the
syslog displayed during the operation and in the output of the show
install log command.
Device and package, expressed in concatenated form (for example,
disk0:asr14k-mgbl-3.7.1).
For the device argument, the value is a specified storage device, typically
disk0:. This is the local storage device where the package was added with
the
Press ? after a partial package name to display all possible matches
available for activation. If there is only one match, press the TAB key to
fill in the rest of the package name.
Note
(Optional) Specifies an abort timer value, time, in minutes, which when
expired loads the last committed loadpath.
(Optional. Administration EXEC mode only) Activates a package for a
specific secure domain router (SDR). The only SDR available is
OWNER, which refers to the entire Cisco ASR 14000 Series Router
router.
install add command.
Multiple packages can be activated at a time. Up to 32 packages
can be specified individually. Multiple packages can be specified
using the wildcard syntax, for example, harddisk:*3.7*. If
multiple Software Maintenance Upgrades (SMUs) are activated,
some SMUs may require a reload. If the operation requires a node
reload, the user is prompted before the installation operation
occurs.
Cisco ASR 14000 Series Router System Management Command Reference
install activate
SMR-341