Management Egress-Interface-Selection; Show Ip Management-Eis-Route - Dell Z9500 Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2.(0.0)

management egress-interface-selection

To make configured application traffic egress through the management port instead of the front-end (FE)
port, enable and configure a management egress interface.
Z9500
Syntax
management egress-interface-selection
To disable and remove management egress interface selection (EIS) configurations,
use the no management egress-interface-selection command.
Defaults None.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2(0.0)

show ip management-eis-route

Display the management routes used by EIS.
Z9500
Syntax
show ip management-eis-route
Defaults None.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Interfaces
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
857