Dell S4810 Reference Manual page 224

•
Parameters
source
mask
any
host ip-address
destination
dscp
count
byte
log
order
monitor
fragments
Defaults Not configured.
Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
224
Use the no deny icmp {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Enter the IP address of the network or host from which the
packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
(OPTIONAL, E-Series only) Enter the keyword log to have
the information kept in an ACL log file.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the section "Flow-
based Monitoring" in the Port Monitoring chapter of the Dell
Networking OS Configuration Guide.
Enter the keyword fragments to use ACLs to control packet
fragments.
Access Control Lists (ACL)