Access-Class; Clear Counters Ip Access-Group - Dell S4810 Reference Manual

The S4810 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the

access-class

Apply a standard ACL to a terminal line.
S4810
Syntax
access-class access-list-name
To remove an ACL, use the no access-class access-list-name command.
Parameters
access-list-
name
Defaults Not configured.
Command LINE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.2.1.1

clear counters ip access-group

Erase all counters maintained for access lists.
S4810
Syntax
clear counters ip access-group [access-list-name]
Access Control Lists (ACL)
Commands Common to all ACL Types
Enter the name of a configured Standard ACL, up to 140
characters.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increase the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
section.
207