Dell S4810 Reference Manual page 247

Defaults none
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage You can assign one ACL (standard or extended) to an interface.
Information
Related
mac access-list standard
Commands
mac access-list extended
Access Control Lists (ACL)
NOTE:
1. If the MAC ACL is applied on VLAN, none of the VLAN members should have
an access list applied for that VLAN.
2. If the MAC ACL is applied on a Physical or Port Channel interface, the VLAN
in which this port is associated should not have an access list applied.
3. If the MAC ACL is applied on a VLAN, then that VLAN should not belong to
VLAN ACL group.
4. If the MAC ACL is applied on a VLAN ACL group, then none of the VLANs in
that group should have an access list applied on it.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— configures a standard MAC ACL.
— configures an extended MAC ACL.
247