Dell S4810 Reference Manual page 217

any
host ip-address
Defaults Not configured.
Command CONFIGURATION-STANDARD-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.10
Access Control Lists (ACL)
Enter the keyword any to specify that all routes are subject
to the filter. You can enter any of the following keywords to
specify route types.
• bytes — Enter the keyword bytes to count bytes
processed by the filter.
• count — Enter the keyword count to count packets the
filter processes.
• dscp — Enter the keyword dcsp to match to the IP
DCSCP values.
• fragments — Enter the keyword fragments to match
to non-initial fragments of a datagram.
• order — Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254
(where 0 is the highest priority and 254 is the lowest;
lower-order numbers have a higher priority). If you do
not use the keyword order, the ACLs have the lowest
order by default (255).
Enter the keyword host then the IP address to specify a host
IP address or hostname.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the
ACL entry.
217