Dell S4810 Reference Manual page 251

mac-source-
address-mask
count
byte
log
monitor
Defaults Not enabled.
Command CONFIGURATION-MAC ACCESS LIST-STANDARD
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Usage
When you use the log option, the CP processor logs detail the packets that match.
Information
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets' details.
Access Control Lists (ACL)
(OPTIONAL) Specify which bits in the MAC address must
match. If no mask is specified, a mask of 00:00:00:00:00:00
is applied (in other words, the filter allows only MAC
addresses that match).
(OPTIONAL) Enter the keyword count to count packets
processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
(OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the "Flow-based
Monitoring" section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added the monitor option.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
251