Dell S4810 Reference Manual page 222

host ip-address
destination
count
byte
log
dscp
order
monitor
fragments
Defaults Not configured.
Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
222
Enter the keyword host then the IP address to specify a host
IP address.
Enter the IP address of the network or host to which the
packets are sent.
(OPTIONAL) Enter the keyword count to count packets that
the filter processes.
(OPTIONAL) Enter the keyword byte to count bytes that the
filter processes.
(OPTIONAL, E-Series only) Enter the keyword log to enter
ACL matches in the log.
(OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the "Flow-based
Monitoring" section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Enter the keyword fragments to use ACLs to control packet
fragments.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Access Control Lists (ACL)