Show Mac Accounting Access-List - Dell S4810 Reference Manual

show mac accounting access-list

Display MAC access list configurations and counters (if configured).
S4810
Syntax
show mac accounting access-list access-list-name interface
interface in | out
Parameters
access-list-
name
interface
interface
in | out
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.5.1.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Access Control Lists (ACL)
Enter the name of a configured MAC ACL, up to 140
characters.
Enter the keyword interface then the one of the following
keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword port-
channel and then enter a number. The range is from 1
to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet and then enter the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE and then enter the slot/port information.
• For a VLAN interface, enter the keyword VLAN followed
by the vlan id.
Identify whether ACL is applied on ingress or egress side.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
249