Standard Ip Acl Commands; Deny - Dell S4810 Reference Manual

Command EXEC Privilege
Modes
Command
Version 9.4.
History
(0.0)
Version 8.5.1.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Example
Dell#show ip access-lists L3-ACL vrf VRF2 in
Standard Ingress IP access list L3-ACL on VRF2
seq 5 permit 10.1.2.0/24
seq 10 permit 20.1.2.0/24
Dell#show ip access-lists vrf VRF2 in
Standard Ingress IP access list L3-ACL
seq 5 permit 10.1.2.0/24
seq 10 permit 20.1.2.0/24
Dell#show ip access-lists
Standard Ingress IP access list test
seq 5 permit 1.1.1.0/24 count (0 packets)
seq 10 deny 2.1.1.0/24 count (0 packets)

Standard IP ACL Commands

When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an
implicit permit.
The S4810 supports both Ingress and Egress IP ACLs.
NOTE: Also refer to the
sections.

deny

To drop packets with a certain IP address, configure a filter.
S4810
Syntax
deny {source | any | host {ip-address}}
To remove this filter, you have two choices:
•
Access Control Lists (ACL)
Added support for VRF.
Added support for the 4-port 40G line cards on ExaScale.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Commands Common to all ACL Types
Use the no seq sequence-number command if you know the filter's
sequence number.
test in
and Common IP ACL Commands
213