Access Control Lists (Acl); Commands Common To All Acl Types; Remark - Dell S4810 Reference Manual

Access Control Lists (ACL)

Access control lists (ACLs) are supported by the Dell Networking operating software on the S4810
platform.
Dell Networking OS supports the following types of ACL, IP prefix list, and route maps:
•

Commands Common to all ACL Types

• Common IP ACL Commands
• Standard IP ACL Commands
• Extended IP ACL Commands
• Common MAC Access List Commands
• Standard MAC ACL Commands
• Extended MAC ACL Commands
• IP Prefix List Commands
• Route Map Commands
• AS-Path Commands
• IP Community List Commands
NOTE: For ACL commands that use the Trace function, refer to the Trace List Commands section in
the Security chapter.
NOTE: For IPv6 ACL commands, refer to
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options.
Some commands in this chapter may use similar names, but require different options to support the
different ACL types (for example, the deny and permit commands).

remark

Enter a description for an ACL entry.
S4810
Syntax
remark [remark-number] [description]
Parameters
remark-
number
204
IPv6 Access Control Lists (IPv6
Enter the remark number. The range is from 0 to
4294967290.
NOTE: You can use the same sequence number for the
remark and an ACL rule.
ACLs).
Access Control Lists (ACL)
7