Show Logging - NETGEAR M6100 Series Reference Manual

show logging

This command displays logging configuration information.
Format
show logging
Mode Privileged EXEC
Term Definition
Logging Client Port on the collector/relay to which syslog messages are sent.
Local Port
Logging Client Shows the configured syslog source-interface (source IP address).
Source Interface
CLI Command Shows whether CLI Command logging is enabled.
Logging
Console Logging Shows whether console logging is enabled.
Console Logging The minimum severity to log to the console log. Messages with an equal or lower numerical severity
Severity Filter are logged.
Buffered Logging Shows whether buffered logging is enabled.
Persistent Logging Shows whether persistent logging is enabled.
Persistent Logging The minimum severity at which the logging entries are retained after a system reboot.
Severity Filter
Syslog Logging Shows whether syslog logging is enabled.
Log Messages Number of messages received by the log process. This includes messages that are dropped or
Received ignored.
Log Messages Number of messages that could not be processed due to error or lack of resources.
Dropped
Log Messages Number of messages sent to the collector/relay.
Relayed
Command example:
(NETGEAR Switch) #show logging
Logging Client Local Port
Logging Client Source Interface
CLI Command Logging
Console Logging
Console Logging Severity Filter
Buffered Logging
Persistent Logging
Persistent Logging Severity Filter
Syslog Logging
M6100 Series Switches
: 514
: (not configured)
: disabled
: enabled
: error
: enabled
: disabled
: alert
: disabled
Utility Commands
186