Show Ip Interface; Show Ip Route - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
Encapsulation
Type
IP MTU

14.2.12 show ip interface

This command displays summary information about IP configuration settings for all ports
in the router.
Format
Modes
Interface
IP Address
IP Mask
Netdir Bcast
MultiCast Fwd

14.2.13 show ip route

This command displays the entire route table. This commands takes no options.
Format
Mode
Network Address
Subnet Mask
Protocol
Total Number of
Routes
14-14
Is the encapsulation type for the specified interface. The
types are: Ethernet or SNAP.
Displays the maximum transmission unit (MTU) size of a
frame, in bytes.
show ip interface
Privileged EXEC
User EXEC
Valid slot and port number separated by forward slashes.
The IP address of the routing interface in 32-bit dotted deci-
mal format.
The IP mask of the routing interface in 32-bit dotted decimal
format.
Indicates if IP forwards net-directed broadcasts on this inter-
face. Possible values are Enable or Disable.
Indicates the multicast forwarding administrative mode on
the interface. Possible values are Enable or Disable.
show ip route
Privileged EXEC
Is an IP address identifying the network on the specified
interface.
Is a mask of the network and host portion of the IP address
for the router interface.
Tells which protocol added the specified route. The possibili-
ties are: local or static.
The total number of routes.
v1.0, November 2007
Routing Commands