Show Ipv6 Route Ecmp-Groups - NETGEAR ProSafe M7100-24X User Manual

Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 route
IPv6 Routing Table - 3 entries
Codes: C - connected, S - static
O - OSPF Intra, OI - OSPF Inter, OE1 - OSPF Ext 1, OE2 - OSPF Ext 2
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
S 2001::/64 [10/0] directly connected,
C 2003::/64 [0/0]
via ::, 0/11
S 2005::/64 [1/0]
via 2003::2,
C 5001::/64 [0/0]
via ::, 0/5
OE1 6001::/64 [110/1]
via fe80::200:42ff:fe7d:2f19,
OI 7000::/64 [110/6]
via fe80::200:4fff:fe35:c8bb,

show ipv6 route ecmp-groups

This command reports all current ECMP groups in the IPv6 routing table. An ECMP group is
a set of next hops used in one or more routes. The groups are numbered arbitrarily from 1 to
n. The output indicates the number of next hops in the group and the number of routes that
use the set of next hops. The output lists the IPv6 address and outgoing interface of each
next hop in each group.
Format
show ipv6 route ecmp-groups
Mode
Privileged EXEC
Example
(switch) #show ipv6 route ecmp-groups
ECMP Group 1 with 2 next hops (used by 1 route)
2001:DB8:1::1 on interface 2/1
2001:DB8:2::14 on interface 2/2
ECMP Group 2 with 3 next hops (used by 1 route)
2001:DB8:4::15 on interface 2/32
2001:DB8:7::12 on interface 2/33
2001:DB8:9::45 on interface 2/34
ProSafe Managed Switch
0/11
00h:00m:23s,
00h:01m:47s,
IPv6 Commands
Null0
0/5
0/11
368