User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
show ip route
This command causes the entire route table to be displayed. This commands takes no options.
Format
Mode
Network Address
Subnet Mask
Protocol
Next Hop Intf
Next Hop IP Address
Total Number of Routes The total number of routes.
show ip route bestroutes
This command causes the entire route table to be displayed. This commands takes no options.
Format
Mode
Network Address
Subnet Mask
Protocol
Next Hop Intf
Next Hop IP Address
Total Number of Routes The total number of routes in the route table.
9-50
show ip route
Privileged EXEC and User EXEC
Is an IP address identifying the network on the specified inter-
face.
Is a mask of the network and host portion of the IP address for the
router interface.
Tells which protocol added the specified route. The possibilities
are: local, static, OSPF or RIP.
The outgoing router interface to use when forwarding traffic to
the next destination.
The outgoing router IP address to use when forwarding traffic to
the next router (if any) in the path toward the destination.
show ip route bestroutes
Privileged EXEC and User EXEC
Is an IP route prefix for the destination.
Is a mask of the network and host portion of the IP address for the
specified interface.
Tells which protocol added the specified route. The possibilities
are: local, static, OSPF or RIP.
The outgoing router interface to use when forwarding traffic to
the next destination.
The outgoing router IP address to use when forwarding traffic to
the next router (if any) in the path toward the destination. The
next router will always be one of the adjacent neighbors or the IP
address of the local interface for a directly attached network.
202-10009-01_060204
Routing Commands