Set Metric-Type - Allied Telesis x310-26FT Command Reference Manual

R M C
OUTE AP OMMANDS
-
SET METRIC TYPE

set metric-type

Overview Use this command to add a metric-type set clause to a route map entry.
When a route matches the route map entry, the device sets its route type to the
specified value.
Use the no variant of this command to remove the set clause.
set metric-type {type-1|type-2}
Syntax
no set metric-type [type-1|type-2]
Mode Route-map Configuration
Usage This command is valid for OSPF routes only.
To use entry 3 of the route map called rmap1 to redistribute matching routes into
Example
OSPF as type-1 external routes, use the commands:
awplus#
awplus(config)#
awplus(config-route-map)#
Related default-information originate
Commands
redistribute (OSPF)
match route-type
route-map
show route-map
C613-50103-01 REV A
Parameter Description
type-1
Redistribute matching routes into OSPF as type-1 external routes.
type-2
Redistribute matching routes into OSPF as type-2 external routes.
configure terminal
route-map rmap1 permit 3
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
set metric-type 1
1077