Config Pim Spt-Threshold - Extreme Networks ExtremeWare Command Reference Manual

Version 7.0.0

Hide thumbs Also See for ExtremeWare:

Table of Contents

IP Multicast Commands

config pim spt-threshold

config pim spt-threshold <last hop router threshold> {<rp threshold>}

Configures the threshold, in kbps, for switching to SPT. On leaf routers, this setting is based on data

packets. On the RP, this setting is based on register packets.

Syntax Description

last hop router threshold

rp threshold

The default setting is 0.

Usage Guidelines

For the best performance leveraged by hardware forwarding, use default value "0,0", or small values

below 16. From release 6.2.2 onwards, since the RP learns the source address from the register message,

the RP threshold has no effect.

The following command sets the threshold for switching to SPT:

config pim spt-threshold 4 16

This command was first available in ExtremeWare 6.1.

Platform Availability

This command is available on all platforms.

Specifies a last hop router threshold.

Specifies an RP threshold.

ExtremeWare Software 7.0.0 Command Reference Guide

Extremeware 7.0.0