Configure Pim Spt-Threshold - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

IP Multicast Commands

configure pim spt-threshold

configure pim spt-threshold <leaf-threshold> {<rp_threshold>}

Configures the threshold, in kbps, for switching to SPT. On leaf routers, this setting is based on data

packets. On the RP, this setting is based on register packets.

Syntax Description

leaf-threshold

rp_threshold

The default setting is 0 for both parameters.

Usage Guidelines

For the best performance, use default value of 0.

The following command sets the threshold for switching to SPT:

configure pim spt-threshold 4 16

This command was first available in ExtremeWare XOS 10.1.

Platform Availability

This command is available on all platforms.

Specifies the rate of traffic per (s,g,v) group in kbps for the last hop. Range is

Specifies an RP threshold. Range is 0 - 419403.

ExtremeWare XOS 11.5 Command Reference Guide

Extremeware xos 11.5