Configure Pim Crp Static - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure pim crp static

configure pim crp static <ip_address> [none | <policy>] {<priority> [0-
254]}
Description
Configures a rendezvous point and its associated groups statically, for PIM sparse mode operation.
Syntax Description
ip_address
none
policy
priority
Default
The default setting for priority is 0, which indicates highest priority.
Usage Guidelines
In PIM-SM, the router sends a join message to the rendezvous point (RP). The RP is a central multicast
router that is responsible for receiving and distributing multicast packets. If you use a static RP, all
switches in your network must be configured with the same RP address for the same group (range).
The policy file contains a list of multicast group addresses served by this RP.
This policy file is not used for filtering purposes. As used with this command, the policy file is just a
container for a list of addresses. So a typical policy file used for RP configuration will look a little
different from a policy used for other purposes.
If routers have different group to RP mappings, due to misconfiguration of the static RP (or any other
reason), traffic will be disrupted.
Example
The following command statically configures an RP and its associated groups defined in policy file rp-
list:
configure pim crp static 10.0.3.1 rp-list
The following is a sample policy file:
entry extreme1 {
if match any {
then { nlri 224.0.0.0/4 ;
nlri 239.255.0.0/24 ;
nlri 232.0.0.0/8 ;
nlri 238.1.0.0/16 ;
ExtremeWare XOS 11.5 Command Reference Guide
Specifies a static CRP address.
Deletes the static rendezvous point.
Specifies a policy file name.
Specifies a priority setting. The range is 0 - 254.
}
configure pim crp static
1815