Disable Bgp Neighbor Capability - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

BGP Commands

disable bgp neighbor capability

disable bgp neighbor [all | <remoteaddr>] capability [ipv4-unicast | ipv4-

multicast | route-refresh]

This command disables BGP Multiprotocol (MP) and route-refresh capabilities for neighbor.

Syntax Description

ipv4-unicast

ipv4-multicast

route-refresh

All capabilities are disabled by default.

If no address family is specified, IPv4 unicast is the default.

Usage Guidelines

This command is not currently supported, and is not recommended for use.

This command disables BGP Multiprotocol and route-refresh capabilities for one or all neighbors. After

the capabilities have been enabled, the BGP neighbor will announce its capabilities to neighbors in an

OPEN message.

The following command disables the route-refresh feature for all neighbors:

disable bgp neighbor all route-refresh

This command was first available in ExtremeWare XOS 10.1.

This command required an Advanced Core license in ExtremeWare XOS 11.1.

Specifies all neighbors.

Specifies an IP address of the BGP neighbor.

Specifies BGP MP unicast capabilities.

Specifies BGP MP multicast capabilities.

Specifies ROUTE-REFRESH message capabilities.

ExtremeWare XOS 11.3 Command Reference

Do you have a question about the ExtremeWare XOS and is the answer not in the manual?

Extremeware xos 11.3