Configure Tacacs Server - Extreme Networks ExtremeWare Command Reference Manual

configure tacacs server

For the "i" switches:
configure tacacs [primary | secondary] server [<ipaddress> | <hostname>]
{<L4 port no>} client-ip <ipaddress>
For the "e" switches:
configure tacacs [primary | secondary] server [<ipaddress> | <hostname>]
{<L4 port no>} client-ip [<ipaddress>]
Description
Configures the server information for a TACACS+ authentication server.
Syntax Description
primary
secondary
ipaddress
hostname
L4 port no
ipaddress
Default
TACACS+ uses TCP port 49.
Usage Guidelines
Configure the server information for a TACACS+ server.
To remove a server, use the following command:
unconfigure tacacs
Use of the
hostname
Example
The following command configures server tacacs1 as the primary TACACS+ server for client switch
10.10.20.35:
configure tacacs primary server tacacs1 client-ip 10.10.20.35
History
This command was first available in ExtremeWare 6.1.
ExtremeWare 7.7 Command Reference Guide
Configures the primary TACACS+ server.
Configures the secondary TACACS+ server.
Specifies the IP address of the TACACS+ server being configured.
Specifies the host name of the TACACS+ server being configured. Must be able to be resolved to
an IP address.
Specifies the L4 port used to contact the TACACS+ server.
NOTE: This option is available only on the "i" switches.
The IP address used by the switch to identify itself when communicating with the TACACS+
server.
parameter requires that DNS be enabled.
configure tacacs server
941