Ip Access-Group - Dell PowerEdge M420 Reference Manual

Example
The following example configures a MAC ACL to deny traffic from MAC
address 0806.c200.0000.
console(config)#mac access-list extended DELL123
console(config-mac-access-list)#deny 0806.c200.0000
ffff.ffff.ffff any

ip access-group

Use the ip access-group command in Global and Interface Configuration
modes to apply an IP based ACL on an Ethernet interface or a group of
interfaces. An IP based ACL should have been created by the access-list
... command with the same name specified in this command.
Use the no ip access-group command to disable an IP based ACL on an
Ethernet interface or a group of interfaces.
Syntax
ip access-group
no ip access-group
name — Access list name. (Range: Valid IP access-list name up to 31
•
characters in length)
direction — Direction of the ACL. (Range: in or out. Default is in.)
•
seqnum — Precedence for this interface and direction. A lower sequence
•
number has higher precedence. Range: 1 – 4294967295. Default is1.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration and Interface Configuration (Ethernet, VLAN, or Port
Channel) modes
250
ACL Commands
name direction] [seqnum]
[
name direction seqnum
name