Dell PowerEdge M420 Reference Manual page 248

Use this command in Mac-Access-List Configuration mode to create a new
rule for the current MAC access list. Each rule is appended to the list of
configured rules for the list.
The command is enhanced to accept the optional time-range parameter. The
time-range parameter allows imposing a time limitation on the MAC ACL
rule as defined by the parameter
specified name does not exist, and the MAC ACL containing this ACL rule is
applied to an interface or bound to a VLAN, then the ACL rule is applied
immediately. If a time range with the specified name exists, and the MAC
ACL containing this ACL rule is applied to an interface or bound to a VLAN,
then the ACL rule is applied when the time-range with a specified name
becomes active. The ACL rule is removed when the time-range with a
specified name becomes inactive.
Syntax
{deny | permit} {{any |
dstmacmask}} [
[[log] [time-range
interface-id
redirect}
Parameter Description
Parameter
srcmac
srcmacmask
any
dstmac
destmacmask
bpdu
ethertypekey
248
ACL Commands
srcmac srcmacmask
ethertypekey 0x0600-0xFFFF
|
time-range-name
]
Description
Valid source MAC address in format xxxx.xxxx.xxxx.
Valid MAC address bitmask for the source MAC address in
format xxxx.xxxx.xxxx.
Packets sent to or received from any MAC address
Valid destination MAC address in format xxxx.xxxx.xxxx.
Valid MAC address bitmask for the destination MAC address in
format xxxx.xxxx.xxxx.
Bridge protocol data unit
Either a keyword or valid four-digit hexadecimal number.
(Range: Supported values are appletalk, arp, ibmsna, ipv4, ipv6,
ipx, mplsmcast, mplsucast, Netbios, novell, pppoe, rarp.)
time-range-name
} {any | bpdu |
] vlan {eq
] [assign-queue
. If a time range with the
dstmac
0-4095
}] [cos
queue-id
] [{mirror |
0-7
]