Mac Address-Table Multicast Forbidden Address - Dell PowerEdge M420 Reference Manual

If switches exist on the VLAN, and IGMP snooping is not enabled, use the
mac address-table multicast forward-all command to enable forwarding all
Multicast packets to the Multicast routers.
Example
In this example, bridge Multicast filtering is enabled.
console(config)#mac address-table multicast filtering

mac address-table multicast forbidden address

Use the mac address-table multicast forbidden address command in Global
Configuration mode to forbid adding a specific Multicast address to specific
ports. To return to the system default, use the no form of this command. If
routers exist on the VLAN, do not change the unregistered multicast
addresses state to
Syntax
mac address-table multicast forbidden address vlan
address ip-multicast-address
|
port-channel | tengigabitethernet}
no mac address-table multicast forbidden address vlan
multicast-address
Parameter Description
Parameter
add
remove
vlan vlan-id
mac-multicast-
address
ip-multicast-address
drop
on the routers ports.
} {add | remove} interface {gigabitethernet |
ip-multicast-address
|
Description
Adds ports to the group. If no option is specified, this is the
default option.
Removes ports from the group.
A valid vlan-id. (Range 1-4093)
MAC Multicast address
IP Multicast address.
vlan-id
interface-list
}
in the format xxxx.xxxx.xxxx.
Address Table Commands
mac-multicast-
{
vlan-id mac-
{
263