Format
no ip helper-address discard
{<1-65535>|dhcp|domain|isakmp|mobile-ip|nameserver|
netbios-dgm|netbios-ns|ntp|pim-auto-rip|rip|tacacs|tftp|time}
Mode
Interface Config
show ip helper-address
Use this command to display the configured helper addresses on the given interface.
Format
show ip helper-address <interface>
Mode
• Privileged EXEC
• User EXEC
The following shows example CLI display output for the command.
(switch) #show ip helper-address 1/0/1
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5
ICMP Throttling Commands
This section describes the commands you use to configure options for the transmission of various
types of ICMP messages.
ip unreachables
Use this command to enable the generation of ICMP Destination Unreachable messages. By
default, the generation of ICMP Destination Unreachable messages is enabled.
Default
enable
Format
ip unreachables
Mode
Interface Config
Routing Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
4-26