Stacking Commands; Dedicated Port Stacking; Stack - NETGEAR ProSafe FSM7326P Cli Reference Manual

This section describes the stacking commands available in the FASTPATH<FPNP>® CLI.
The stacking commands are available on the FASTPATH 4000 Platform.
The Stacking Commands section includes the following topics:
• Section 17.1 "Dedicated Port Stacking" on page 17-1
• Section 17.2 "Front Panel Stacking Commands" on page 17-10
The commands in this section are in one of two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration
setting.
Note: The Primary Management Unit is the unit that controls the stack.

17.1 Dedicated Port Stacking

This section describes the commands you use to configure stacking.

17.1.1 stack

This command sets the mode to Stack Global Config.
Format
Mode

Stacking Commands

Stacking Commands
stack
Global Config
v1.0, March 2006
Chapter 17
17-1