Configuring The Working Interface - Juniper PHYSICAL LAYER - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Physical Layer Configuration Guide

Configuring the Working Interface

To configure the working interface:
1.
2.
3.
aps group
aps working
threshold
90
Configuration Tasks
Select the interface.
host1(config)#controller sonet 4/0
Specify the APS group to which the working and protect interfaces will belong.
host1(config-controll)#aps group boston
Specify the interface as the working interface.
host1(config-controll)#aps working
Use to specify the group to which the working and protect interfaces will belong.
Specify the name of the APS group.
Example
host1(config-controll)#aps group boston
Use the no version to remove a group of APS interfaces.
See aps group.
Use to specify the working interface.
Optionally, you can specify 1 as the channel number for the working interface.
Because the working interface is always assigned channel number 1, this is the
only valid option.
Examples
host1(config-controll)#aps working
host1(config-controll)#aps working 1
Use the no version to prevent the interface from acting as a working interface.
See aps working.
Use to set thresholds for the bit error rates associated with APS/MSP alarms.
This command does not apply to the working interface. You can issue this
command only for the protect interface.
Specify one of the following keywords to indicate the alarm level:
sd-ber Bit error rate that specifies signal degradation
sf-ber Bit error rate that specifies signal failure