Table of Contents
Advertisement
VXA2000 Series Media Flow Engine Quick Start
Configuring and Operating the Media Flow Engine
Safety Guidelines and Warnings
8
Likewise, you can log in to the Management Console by entering the IP address in a
browser window and using admin as the login name. The Management Console has a
subset of the CLI commands; these commands are sufficient for simple configurations.
Each user account has at least one privilege level that determines what commands the
user can issue and what CLI modes the user can access:
Administrator (admin)—Full privileges. Can enter Enable mode and Config mode.
Monitor (monitor)—Can read all data and perform all actions, but not change any
configuration. Can enter Enable mode from Standard mode but cannot change
configurations.
Unprivileged (unpriv)—Can issue a small subset of commands including debugging
and show commands. Can log in to Standard mode only.
You are now ready to configure the appliance. Media Flow Controller software is included
on every Media Flow Engine.
For complete information about configuring the Media Flow Controller software, see the
Juniper Networks Media Flow Controller Administrator's Guide and CLI Command Reference.
For complete information about configuring Media Flow Manager, see the Media Flow
Manager Administrator's Guide and CLI Command Reference.
The following guidelines help ensure your safety and protect the VXA Series Media Flow
Engine from damage. The list of guidelines might not address all potentially hazardous
situations in your working environment, so be alert and exercise good judgment at all
times.
WARNING: This section is a summary of safety guidelines and warnings. For a complete
list of guidelines and warnings for this appliance, see the VXA2000 Series Media Flow
Engine Hardware Installation Guide at
CAUTION: Before removing or installing any appliance components, attach an ESD
strap to an ESD point and place the other end of the strap around your bare wrist. Failure
to use an ESD strap can result in damage to the appliance components.
Perform only the procedures explicitly described in the hardware documentation for
this product. Make sure that only authorized service personnel perform other system
services.
Keep the area around the chassis clear and free from dust before, during, and after
installation.
http://www.juniper.net/techpubs/
Copyright © 2010, Juniper Networks, Inc.
.
Advertisement
Table of Contents
