Configuring Poe; Chapter 9 Configuring Poe; Configuring Power Over Ethernet (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER - NSM CONFIGURATION GUIDE FOR EX SERIES DEVICES REV 3 Configuration Manual

CHAPTER 9

Configuring PoE

Configuring Power over Ethernet (NSM Procedure)

Table 70: PoE Edit Settings
Option Description
Name Specifies the name for the interface.
Copyright © 2010, Juniper Networks, Inc.
This section contains the following:
Configuring Power over Ethernet (NSM Procedure) on page 115
EX-series switch models provide either 8, 24, or 48 PoE ports, which supply electric power
over the same ports that are used to connect network devices. These ports allow you to
plug in devices that require both network connectivity and electric power, such as VoIP
phones, WAPs, and some IP cameras.
The factory default configuration for EX-series switches specifies and enables PoE
interfaces for the PoE ports.
To configure PoE:
In the navigation tree, select Device Manager > Devices. In Device Manager, select
1.
the device for which you want to configure PoE.
In the configuration tree, select PoE
2.
Enter a value to set the guard band value. The default value is 0. Guard band Specifies
3.
the band to control power availability on the switch.
To add/modify PoE interface details, click Add New Entry and select Interface.
4.
In the Interface screen, click the add or edit icon.
5.
Add/modify PoE settings for the interface as specified in Table 70 on page 115
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
Enter a name.
115