Danfoss iC7 Motion Series Application Manual page 99

Application Guide | iC7 Series Motion
Table 30: Overview of data types (continued)
Data type Description
ULINT Unsigned long integer
DATE_AND_TIME Date and time information
Understanding Parameter Types
6.1.3
The following table lists the different types of parameters.
Table 31: Parameter Types and Descriptions
Parameter Type
Selection
Range (0–255)
Range (*–*)
Range (0–*)
Range (Unit dependent)
Understanding Access Types
6.1.4
The following table lists the different parameter access types.
Table 32: Parameter Types and Descriptions
Access Type
Read/Write
Read only
Read/Conditional Write
Grid (Menu Index 1)
6.2
Grid Overview
6.2.1
This parameter group contains parameters for configuring and monitoring the energy source of the drive system. Typically, the energy
source is the grid. The menu also lets the user configure grid protection settings and view the condition of the grid.
Grid Status (Menu Index 1.1)
6.2.2
P 1.1.1 Grid Frequency
Description: Shows the actual grid frequency.
© 2023.11
Size
(Bits)
64
64
Description
The parameter provides of a list of value selections.
The value of the parameter is within the specified range. In this example, the parameter can have
any value between 0 and 255.
The value of the parameter can be set within the full range of the data type REAL. See
standing Data Types.
The value of the parameter can be set within the upper range of the data type REAL. See
derstanding Data Types.
The range depends on the selected unit, and is visible in MyDrive Insight and the Control Panel.
Description
The parameter information can be read or changed.
The parameter information can only be read.
The parameter information can be read and changed. The parameter settings cannot be modified
when the drive is running. The drive must be coasted to modify parameter values.
Range
0–18446744073709551615
N/A
AB318753549016en-000301 / 136R0284 |
6.1.2 Under-
6.1.2 Un-
97