Danfoss iC7 Motion Series Application Manual page 273

Application Guide | iC7 Series Motion
Selection Number
0
1
2
P 5.18.2.2.4 Touch Probe 2 Reset Counter
Description: Enable reset of touch probe 2 counter. Reset of the counter is also possible while the touch probe is active.
Default Value: 0 [Disabled]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
P 5.18.2.2.5 Touch Probe 2 Mode
Description: Select if touch probe 2 monitoring automatically ends after a single event was detected or if a continuous monitoring shall
be done.
Default Value: 1 [Continuous]
Unit: -
The following are the selections for the parameter.
Selection Number
0
1
P 5.18.2.2.6 Touch Probe 2 Enable Position Window
Description: Enable a position window defined by touch probe 2 first and last position for acceptance of events.
Default Value: 0 [Disabled]
Unit: -
The following are the selections for the parameter.
© 2023.11
Selection Name
Rising
Falling
Both
Parameter Type: Selection
Data Type: BOOL
Selection Name
Disabled
Enabled
Parameter Type: Selection
Data Type: UINT
Selection Name
Single Shot
Continuous
Parameter Type: Selection
Data Type: BOOL
Selection Description
Parameter Number: 890
Access Type: Read/Write
Selection Description
Disables the function.
Enables the function.
Parameter Number: 891
Access Type: Read/Write
Selection Description
Parameter Number: 885
Access Type: Read/Write
AB318753549016en-000301 / 136R0284 |
271